Skip to content

M2X Data Service - [AT@SOCKDIAL=1ERROR] - SIM is registered?

[AT@SOCKDIAL=1ERROR] - SIM is registered?
09.11.2017 12:02 PM
The error I am getting after setup and looking at the informaiton in the emulator is the following:

 
Send: AT
[ATOK]
Send: ATE1
[ATE1OK]
Send: AT%PDNSET=1,m2m.com.attz,IP
[AT%PDNSET=1,m2m.com.attz,IPOK]
Send: AT@INTERNET=1
[AT@INTERNET=1OK]
Send: AT@SOCKDIAL=1
[AT@SOCKDIAL=1ERROR]


This error keeps repeating constantly. I run the diagnostics and it states devices error.

This is my last hope before sending the board back.

Any advice/assistance would be appreciated.

Sincerely,
Scott  
Re: [AT@SOCKDIAL=1ERROR] - SIM is registered?
09.11.2017 12:33 PM
Hi Scott,

Are you using an AT&T Starter Kit device?

If so, could you please post your question on the AT&T Starter Kit forum[1] or you can open a support ticket via the "Contact Support" link in the footer of the Starter Kit homepage[2].


[1]: https://developer.att.com/forums/at-t-iot-starter-kit
[2]: https://marketplace.att.com/iot-starter-kits